Partners Blog Contacts

New firmware for the Phoenix PowerHub and Quattro is needed to support this functionality. This firmware will be included as part of the VidyoRoom version 3.3.21 installer. Phoenix will provide the new firmware for the Phoenix Spider devices to support these controls in the near future. 

To configure the advanced Phoenix settings:

  1. Click the Settings tab.

    Configuring_the_Advanced_Phoenix_Settings_1.png

  2. Click the blue triangle next to the word Advanced Phoenix Settings to view the advanced Phoenix settings if needed.

    By default, Phoenix Super Sensitive Mode is disabled, enabling the Automatic Volume Control, Automatic Gain Control, Noise Cancellation, and Mixer settings.

    Deselecting the Automatic Gain Control, Noise Cancellation, and Mixer checkboxes enables Phoenix Super Sensitive Mode. If you do not want to retain these default settings, then you can always make configuration changes to meet your specific needs.

    Caution: You should only adjust the advanced Phoenix settings if you have the knowledge and expertise to make configuration changes. Otherwise, consult an expert or retain the default system configurations.



  3. Deselect the Automatic Volume Control checkbox if you do not want to adjust the volume or loudness of the audio signal.

  4. Deselect the Automatic Gain Control checkbox if you do not want to automatically control the gain of the audio signal.

  5. Deselect the Noise Cancellation checkbox if you do not want to reduce background noise.

  6. Deselect the Mixer checkbox if you do not want to route or change the volume level and dynamics of the audio signal.

  7. Click the Super Sensitive On button if you want the audio to be received in its native state if not already enabled.

  8. Click the Super Sensitive Off button if you want the audio to be processed by the Phoenix Quattro device if not already enabled.

    The remote control API can still be used to enable or disable Phoenix Super Sensitive Mode. Phoenix Super Sensitive Mode remains in effect until the end of the call. Since Phoenix Super Sensitive Mode is automatically disabled by default, it has to be re-enabled at the beginning of each call.

    If the Phoenix Quattro device is connected to a Phoenix PowerHub, then the All Microphones and Single Microphone radio buttons will not display.



  9. Select the All Microphones radio button if you want audio to be heard from all microphones on the Phoenix Quattro device.

  10. Select the Single Microphone radio button if you want audio to be heard from only one microphone on the Phoenix Quattro device.

    The Admin UI does not allow you to select a specific microphone. The second microphone inside the Phoenix Quattro device is selected as the single microphone by default when the Single Microphone radio button is selected.

    Selecting the Single Microphone radio button is only allowed when the Phoenix Quattro device is plugged directly into the VidyoRoom system instead of being daisy chained via the Power Hub.



  11. Click the Save button.

    Changes made here are not applied to the Phoenix device until the Save button is clicked.



    If Write Protection Mode is enabled, Phoenix Super Sensitive Mode will automatically be disabled after clicking the Save button. After the VidyoRoom system is rebooted, Phoenix Super Sensitive Mode will revert back to its previous state prior to Write Protection Mode being enabled.
Was this article helpful?
0 out of 0 found this helpful

0 Comments

Follow
Please sign in to leave a comment.